Setting Up Your Hookah

Charcoal Screen		Separates the charcoal from the tobacco
Clay Bowl		Holds the shisha
Bowl Grommet		Seals the bowl
Tray		Catches falling ashes
Shaft		Enables the smoke to pass from the bowl to the base
Hose Grommet		Seals the hose
Air Valve		Enables smoke release when the base fills to its capacity
Base Grommet		Seals the base
Glass Base		Smoke chamber. Should be filled with about one inch of water to filter the smoke
Hose		Enables you to draw the tasty smoke from the hookah

Fill your base with water. About one inch of water should do it.
Use a small amount of water to moisten the Base Grommet for fitting.
Place your Shaft into the Base and rotate clockwise slowly.
Fasten the Snap-On Tray over the Shaft.
Fasten the Bowl grommet over the Shaft.
Gather your Flavored Tobacco, Tongs, Metal Bowl screen (or foil).
Unpack or loosen the Flavored Tobacco. This will make it easier to load into your hookah and will give you a smoother smoke.
Without overfilling the bowl, lightly place your loosened tobacco into the clay bowl.
Fasten a screen (or foil) over the Bowl.
If you are not using a proper screen and you are using foil, be sure to poke small holes into the Foil. Attach your Bowl to the top of the Shaft, by fastening it onto the Bowl Grommet.
Hold a piece of Charcoal WITH YOUR TONGS, light the charcoal and place it on top of the Metal Bowl Screen (or foil).
Puff on the hookah a few times to wake it up.

NOTE ON TOBACCO * The tobacco should never burn.
Avoid burning your tobacco by keeping your bowl moist.
Keep your bowl moist by using fresh tobacco and by making sure there is adequate water in your base.